izaya/collapseos
1
1
Fork 0
Code Issues Pull Requests Releases Wiki Activity

doc: add AVR documentation

Browse Source
This commit is contained in:
Virgil Dupras 2020-08-30 08:42:33 -04:00
parent 85f8543e17
commit 286f8968fd
1 changed files with 50 additions and 0 deletions
Show Stats Download Patch File Download Diff File Expand all files Collapse all files

50
doc/avr.txt Normal file
View File

@ -0,0 +1,50 @@
# Working with AVR microcontrollers
# Assembling AVR binaries
TODO
# Programming AVR chips
To program AVR chips, you need a device that provides the SPI protocol. The
device built in the rc2014/sdcard recipe fits the bill. Make sure you can
override the SPI clock because the system clock will be too fast for most AVR
chips, which are usually running at 1MHz. Because the SPI clock needs to be a
4th of that, a safe frequency for SPI communication would be 250kHz.
Because you will not be using your system clock, you'll also need to override
SPI_DELAY in your xcomp unit: the default value for this is 2 NOP, which only
works when you use the system clock.
Alternatively, you could run your whole system at 250kHz, but that's going to be
really slow.
The AVR programmer device is really simple: Wire SPI connections to proper AVR
pins as described in the MCU's datasheet. Note that this device will be the same
as the one you'll use for any modern SPI-based AVR programmer, with RESET
replacing SS.
(TODO: design a SPI relay that supports more than one device. At the time of
this writing, one has to disconnect the SD card reader before enabling the AVR
programmer)
The AVR programming code is at B690.
Before you begin programming the chip, the device must be deselected. Ensure
with "(spid)".
Then, you initiate programming mode with "asp$", and then issue your commands.
At this time, only fuse commands are implemented. You get/set they values with
"aspfx@/aspfx!", x being one of "l" (low fuse), "h" (high fuse), "e" (extended
fuse).
Each command will verify that it's in sync, that is, that its 3rd exchange
echoes the byte that was sent in the 2nd exchange. If it doesn't, the command
aborts with "AVR err".
At the time of this writing, it is recommended that you perform your commands in
batch, that is, running your commands right after the "asp$" command, ending
your batch with "(spid)" so that the next batch works. In my tests, interacting
with the chip "live" in a single "asp$" session sometimes resulted in unreliable
data that didn't properly detect sync errors. TODO: investigate further.