85f8543e17
After having done my initial handshaking, I thought the rest of the job was only a matter of implementing the protocol, but I was wrong. There were many issues to fix before I could reliably communicate with my 328P, mostly timing. Now, I seem to be able to reliably extract fuse information, but only in batch mode (that is, run "asp$ aspfl@" directly, then running "(spid)" before running the next command). If I try to interact with the chip in a single asp$ session, I sometimes get wrong values (but no sync error! that's worrying...).
8 lines
200 B
Plaintext
8 lines
200 B
Plaintext
AVR SPI programmer
|
|
|
|
This program allows you to access AVR chips Flash memory, EEPROM
|
|
and fuses using a SPI relay. This requires drivers that imple-
|
|
ment the SPI Relay protocol.
|
|
|
|
Load range: B691-BXXX
|